Mitsubishi Eclipse 1990 Service Manual page 1251

AUTOMATIC
(e) Fit the special tool (outer) to ffie
Turn the outer cylinder clockwise and the inner
counterclockwise to unlock the lock nut and the special'
tool
Caution
When unlocking is carried
to both
(9
Tighten the lock nut by hand
Then, use torque wrench to
the specified torque.
Tightening torque: 29 Nm
Caution
The lock nut may turn
tightened quickly with
wrench.
(g) Remove the special tool for securing the piston. Install
the plug to the Low/Reverse pressure outlet and tight-
en to the specified torque.
a new D-ring in the
the switch into the case and secure it
the park/neutral position
lever and tighten the manual. control'
specified torque.
TSB Revision
(inner).
l o o s e n ,
servo
and manual control
,
force
the piston.
the lock nut to'
adjusting rod if
or torque
the snap ring.
nut to the