Mitsubishi Eclipse 1990 Service Manual page 1172

Table of Contents

Advertisement

I
AUTOMATIC TRANSAXLE
ENGINE (NON-TURBO)>
(1) Remove the EATX relay.
(2) Check the continuity between the EATX relay terminals
4 and 6.
(3) Use jumper leads to connect EATX relay terminal 4 to
the battery
terminal.
(4) Check the continuity between EATX relay terminals 2
and 8 while connecting and disconnecting the' jumper
lead at the battery
Jumper
Connected
Disconnected
STOP LIGHT SWITCH CHECK
Refer to GROUP
SOLENOID CHECK
(1) Disconnect the solenoid and pressure switch assembly
connector.
(2) Measure the resistance between the solenoid and
pressure switch assembly side connector terminals 4
and 6.
Standard value: Approx. 1
(3) If the resistance is outside the standard value, replace
the
SOLENOID CHECK
(1) Disconnect the solenoid and pressure switch assembly
connector.
(2) Measure the resistance between the solenoid and
0
pressure switch assembly side connector terminals 3
and 6.
Standard value: Approx.
(3) If the resistance is outside the standard value, replace
the solenoid and pressure switch assembly.
TSB Revision
On-vehicle Service
terminal and terminal 6 to the battery
terminal.
Terminal
lead
On-vehicle Service.
solenoid and pressure switch assembly.
Terminal 8
2
[at
[at

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents