Mitsubishi Eclipse 1990 Service Manual page 1531

FRONT AXLE
Protrudingportion
B.J. boot band
section
Bearing
the B.J. boot band (large) along, the
portion, and install it so that,, there is
the other side.
the special tool to crimp the B.J.
in the same way as the step
that the crimped width (E) is within the
value.
Standard value (E): 2.4
<When more than 2.6 mm'
Readjust the dimension
the value calculated
and repeat step (12).
5.8 mm
Example: If (E) is 2.9 mm
mm
I
<When less than 2.4 mm
Remove the B.J. boot band, readjust the
dimension (W) of step (10) to the value
calculated by
a new B.J. boot band to repeat steps (11) to.
5.8 mm
Example: If (E) is 2.3
mm
that the boot band is
is secured incorrectly, repeat steps
it.
SPIDER ASSEMBLY' INSTALLATION
Install the spider assembly to the shaft from the direction
of the
CENTER BEARING INSTALLATION
2.8
of
in.)
in.),
in.):
in.)>
equation, and use
in.)
in.).
correctly.
(13) to replace
section.
__ ,
(10) to
equation,'
is 2.9
is 3.5