Mitsubishi Eclipse 1990 Service Manual page 1787

Pressure
NOTE
l or 217
and
2: Enaine (Turbo) and
Engine>
Engine (Non-turbo)>
STEERING
POWER
Shut-off valve
Disconnect the
then connect the special tools.
2. Bleed the air, and then turn the
times while the
ture of the fluid
3. The engine should be idling.
4. Disconnect the connection of the connector for the pres-
sure switch, and place an ohmmeter in position.
5. Gradually close the shut-off valve of the pressure gauge
and increase the hydraulic pressure then check
or not the hydraulic pressure that activates the switch
is the standard value.
Standard value:
6. Gradually open the shut-off valve and reduce the hydraulic
pressure; then check whether or not the hydraulic pressure
that deactivates the switch is the standard value.
Standard value: 0.8
Remove the special tools, and
hose to the specified torque.
8.
Bleed the, system.
Engine
(Non-turbo)>
TSB Revision
PRESSURE
from
is-not
rises to
(213-284 psi)
(114 psi) or less
tighten' the pressure
bump, and