Mitsubishi Eclipse 1990 Service Manual page 962

Drive bevel gear
mount adjusting
Drive bevel gear
spacer
preload adjusting
MANUAL TRANSAXLE OVERHAUL
' D r i v e n
bevel
gear
mount
adjusting
spacer
Driven
bevel gear
preload
adjusting
spacer
22210129
TSB Revision
Transfer
R e m e d y
Use thinner driven bevel gear mount adjusting spacer,
to briiig the driven bevel gear
bevel gear.
NOTE
(1) If' correct tooth contact cannot
change of the driven
spacer, increase or decrease;
bevel gear preload adjusting,
bevel gear mount
and then adjust
When the driven 'bevel gear height is too small
if the thinnest driven bevel gear mount adjusting
spacer 0.13 mm
Replace the drive bevel gear mount adjusting spacer
that is in use with one
replace the drive bevel preload adjusting spacer that
is in use with one that is
When the driven bevel
if the thickest driven
Replace the drive. bevel gear mount
that is in use with one that is
replace the drive bevel gear preload adjusting spacer
equal or close to the standard pattern
to the standard pattern by above adjustment, replace
the drive bevel gear and
I
closer to the drive
. .
in.) is used:
rank thicker and
'thinner.
too large even
__
as a set
,
,