Mitsubishi Eclipse 1990 Service Manual page 997

MANUAL TRANSAXLE
Revision
Gear Case Overhaul
SHIFTER SELECTOR SHAFT
REMOVAL
(1) Thread
(2) Install onto tool and remove bushing using
slide hammer.
INSTALLATION
(1) Position replacement
(2) Using an appropriate size deep well socket, install bushing
in selector shaft bore.
SHIFTER CROSSOVER
REMOVAL
(1) Install through the crossover bushing.
(2) Thread nut and washer onto
(3) Using the
ing.
INSTALLATION
(1 Position the replacement crossover shaft bushing over
the crossover shaft bushing bore.
(2) Using an appropriate size deep
crossover shaft bushing into the bushing bore.
REAR BEARING OIL FEED TROUGH
REMOVAL
The bearing oil feed trough is retained in the case by a pin
that is molded into the case and clips that are part of the
trough.
(1) Using light plier pressure, squeeze the clips together at
the rear of the trough.
Slide the trough
over the retaining' pin that locates the
trough in the case.
Reverse removal procedure to
into bushing.
over selector shaft bore.
remove the crossover shaft bush-
socket, install the
.
feed