Mitsubishi Eclipse 1990 Service Manual page 1149

Code Scan tool 33
No.
General scan tool
Pressure switch falls to respond within specified time for given temperature range.
Carry out the inspection procedure for code No. 31. (Refer
to
Carry out the inspection procedure for code No. 32. (Refer
to
Code Scan tool 35
No.
General scan tool
No pressure is present for any element.
Code Scan tool 38
No.
General scan tool
Fault happened within 1.3 second of a shift (This code is not stored alone. It
a speed error (codes through 58) is detected immediately after a
Code Scan tool 37
No.
General scan tool
Three unsuccessful attempts shift
Electronically Modulated Converter Clutch (EMCC) operation is inhibited
check
- Measure the torque converter clutch off
'Use the scan tool to erase diagnostic trouble
codes.
Drive the vehicle in overdrive until it is fully
warmed up.
Drive in gear overdrive for a minimum of
10 seconds.
NOTE
The vehicle speed must be greater than 80
(50 mph).
Throttle must be open greater than 6 degrees.
Standard value: Less than 69
ROAD TEST
OK: Code 38 set.
Replacethetorqueconverterandtransmissionfluid
cooler.
AUTOMATIC TRANSAXLE
ENGINE (NON-TURBO)>
Hydraulic pressure
Check level
Fault immediately after a shift
Solenoid switch valve latched in
the LU position
gear.
Lock-up control out of range
NG
I
control
(10 psi)
Check the transmission fluid level.
Possible cause:
Internal transaxle failure. (Refer to
TSB Revision
Troubleshooting
switch:
Low/high fluid level in transaxle
Malfunction
Internal transaxle problem
Probable cause
Malfunction of oil filter
Missing O-ring
Malfunction of transmission fluid cooler
Probable cause
if
Internal transaxle problem
(Refer to Speed errors)
Probable
Internal transaxle problem
Refer to Inspection
code. (Internal transaxle problem
Probable cause
Low/high fluid level in
I n t e r n a l
valves.
OK
,
.
fluid level in
for diagnostic trouble
p r o b l e m
..< .
-
NG
Repair
I