Mitsubishi Eclipse 1990 Service Manual page 1847

I I
I
Windshield
BODY
REMOVAL
(1) For protection of the body
'tape to all around the body where the glass is installed.
(2) Using a cutter knife, cut off
along its edge.
I
(3) Run a wire between the glass and the body
portion of the quarter window and
along the glass to cut through the adhesive.
When doing so, pay attention to the clip grommet.
C a u t i o n
Hold the window glass
vent it from falling when the adhesive& cut through.
(4) Using a sharp knife, scoop out existing adhesive from.
the body flange to 2 mm
around the window opening.
(5) Finish smooth the flange surface.
Caution
1.
(6) Degrease using with isopropyl alcohol.
Caution
After degreasing, allow three
well before next work. Do not touch the degreased
surface.
INSTALLATION SERVICE
Dual-lock
After making sure that there are no bends or
in the dual-lock fasteners, attach the dual-lock fasteners to
the
TSB Revision
and Window
POINT
REMOVAL
Do not remove the adhesive more than
Use care not to
the body with the knife. If it is' damaged,
retouch paint or anti-corrosive.
F A S T E N E R
shown in the illustration.,
,
apply
window
and forth
. .
the to pre-,
in.) or less thickness all
apply
to dry
sections
of