Mitsubishi Eclipse 1990 Service Manual page 1196

Terminal
Flat-tip screw driver
Sleeve
Selector lever
Detent pin
AUTOMATIC TRANSAXLE
ENGINE
OVERDRIVE SWITCH
LIGHT CONNECTOR CASE REMOVAL
Use a flat-tip screwdriver or similar tool to pull out the terminal
from the overdrive switch/position indicator light connector
case.
OVERDRIVE SWITCH
SWITCH REMOVAL
(1) Use a flat-tip screwdriver to remove the overdrive switch
button.
(2) Remove the overdrive switch mounting screw.
(3) Pressing the switch,
REASSEMBLY SERVICE POINTS
DETENT SPRING ASSEMBLY
Shift the selector lever to the neutral
install the detent spring assembly so that the roller is in the
detent plate groove.
SELECTOR KNOB
(1) Put the selector lever in the "N" position, turn the sleeve
and adjust the dimension between the sleeve and the
end of the lever so it reaches 16 mm (1.02 in.)
(2) Install the selector knob.
(3) Check that dimension (A)
detent pin reaches the standard value.
Standard value (A): 1.7-2.4
(4) If outside the standard value, remove the selector knob
and turn the sleeve again to readjust.
TSB Revision
Transaxle Control
POSITION
remove the overdrive switch.
position, and then
the detent plate
in.)