Mitsubishi Eclipse 1990 Service Manual page 1246

AUTOMATIC TRANSAXLE
OVERHAUL
micrometer. Add the measured 'solder thickness
the value 0.38 mm
gasket thickness.
Then subtract from that sum a
the specified end play.
The result obtained is the thickness of the spacer to
selected.
Select a spacer whose thickness falls
determined by the formulas below:
[T 0.38 mm
[T 0.38 mm
the spacer which was selected
the outer race on the
silicone grease to all gasket surfaces of the transaxle
case.
a new gasket on the transaxle case.
Caution
Do not reuse the gasket which was previously re-
moved.
converter housing and tighten the 14 bolts indicated
by arrows to the specified torque.
Tightening torque: 21 Nm
the end clutch shaft, inserting the end that has
the longer splines first.
TSB Revision
the thickness of the flattened" solder using a
which corresponds
in.) 0.13 mm
in.) 0.08 mm
. .
to'
the
corresponding to
.
the range
in.)] to
in.)]
(60) and
.