Mitsubishi Eclipse 1990 Service Manual page 1118

AUTOMATIC TRANSAXLE
ENGINE (TURBO) AND
Front roll
stopper
bracket
I - -
Centermember
Washer
TSB Revision
ENGINE> Transaxle Assembly
(2) Remove the connection bolts while turning the crankshaft.
(3) Press the torque converter into the transaxle for easier
removal.
(4) Remove the transaxle assembly mounting bolt and lower
the transaxle assembly.
INSTALLATION SERVICE POINTS
TRANSAXLE ASSEMBLY INSTALLATION
After securely inserting the torque converter into the transaxle
so that the value shown in the illustration becomes the refer-
ence value, install the transaxle assembly to the engine.
value (A): Approx. 16.3 mm
Reference
CENTERMEMBER ASSEMBLY INSTALLATION
If the shown in the illustration is outside the standard
value when the weight of the engine is on the body, replace
the front roll stopper bracket assembly.
Standard value (A):
SHAFT WITH INNER SHAFT
CONNECTION/
DRIVE SHAFT INSTALLATION
Temporarily install the drive shaft so that the inner shaft or
T.J. case of the drive shaft is perpendicular to the transaxle.
Caution
Do not damage the oil seal by the serrated part of the
drive shaft.
DRIVE SHAFT NUT INSTALLATION
(1) Install the drive shaft washer in the specified direction.
mm (1.69512 in.)
I