Mitsubishi Eclipse 1990 Service Manual page 1071

AUTOMATIC TRANSAXLE
ENGINE (TURBO) AND
TORQUE CONVERTER CLUTCH SOLENOID CHECK
1. Disconnect the TCC solenoid connector.
2. Measure the resistance between the TCC solenoid side
3. If the resistance is outside the standard value, replace
PRESSURE CONTROL SOLENOID VALVE
CHECK
1. Disconnect the PCSV connector.
2. Measure the resistance between the PCSV side connector
3. If the resistance is outside the standard value, replace
CHECK
1
3. If the resistance is outside the standard value, replace
1 Disconnect the SCSV-B connector.
3. If the resistance is outside the standard value, replace
TSB Revision
ENGINE> On-vehicle Service
connector terminal 2 and the body ground.
Standard value: Approx. 13
the solenoid valve assembly.
terminal 1 and the body ground.
Standard value: Approx. 3
the solenoid valve assembly.
CONTROL SOLENOID VALVE A (SCSV-A)
Disconnect the SCSV-A connector.
Measure the resistance between the SCSV-A side connec-
tor terminal 3 and the body ground.
Standard value: Approx. 22
the solenoid valve assembly.
SOLENOID VALVE
Measure the resistance between the SCSV-B side connec-
tor terminal 4 and the body ground.
Standard value: Approx. 22
the solenoid valve assembly.
[at
[at
23100520033
[at
(SCSV-B)
[at