Mitsubishi Eclipse 1990 Service Manual page 1148

Code Scan tool 31
No.
General scan tool
Pressure switch falls to respond within specified time for given temperature range.
Hydraulic pressure check
Measure the overdrive clutch pressure
engine
Disconnect the solenoid and pressure switch
assembly connector and apply system voltage
between terminals (6) (8).
WARNING: FRONT WHEELS MUST BE OFF
THE GROUND BEFORE PRO-
CEEDING.
NOTE: Step on the brake pedal so the wheels won't
rotate.
Select lever:
Increase the engine speed slightly.
Standard
every 3 seconds
Check the transmission fluid level.
NG
Repair
Code Scan tool 32
No.
General scan tool
Pressure switch falls to respond within specified time for given temperature range.
Hydraulic pressure check
Measure the 2-4 clutch pressure
Start engine
WARNING: FRONT WHEELS MUST BE OFF
THE GROUND BEFORE PRO-
CEEDING.
on the brake pedal so that wheels
won't rotate.
Select lever:
increase the engine speed slightly.
S t a n d a r d
everv 3 seconds
NG
Check the transmission fluid level.
NG
AUTOMATIC TRANSAXLE
ENGINE (NON-TURBO)>
Hydraulic pressure switch: OD
OK
Check the following
Replace the solenoid and pressure switch
bly.
(75-95 psi)
Solenoid and pressure switch assembly
Hydraulic pressure switch: 2-4
(75-95 psi)
OK
Possible causes:
Solenoid and pressure switch assembly
internal transaxle failure. (Refer to
TSB Revision
Troubleshootihg
Probable
Low/high fluid level in transaxle
Malfunction of pressure switch assembly
Internal transaxle problem
OK
Internal transaxle failure. (Refer to
Probable cause
Low/high fluid level in transaxle
Malfunction of pressure switch assembly
Internal transaxle problem
following connector
OK
the solenoid and pressure switch assem-
NG
Repair
NG
Repair