Mitsubishi Eclipse 1990 Service Manual page 983

MANUAL TRANSAXLE
speed
Sleeve
speed
speed
Stop ring gear
gear
Caged
TSB Revision
INPUT SHAFT
Before disassembly of the input shaft, it
the synchronizer stop ring gap. Use a
the gaps between the stop rings and the speed gears.
The correct gaps are listed below:, ,
m m
m m
1.37-1.93 mm
1.41-1.97 mm
1.37-1.93 mm
If a stop ring gap does not fall within. the
must be insepcted for wear and
synchronizer stop ring is worn
plete output shaft assembly must be
The input shaft incorporates the
gears and synchronizers on the assembly..
(1) Install behind
ring at synchronizer hub on input shaft,
(2) Remove synchronizer and gear using shop press.
(3) Remove caged needle bearing.
to
to measure
i n . )
If or
the
and speed.
.
speed gear. Remove snap
it