Mitsubishi Eclipse 1990 Service Manual page 1634

S U S P E N S I O N
INSTALLATION SERVICE POINT
, STABILIZER BAR BRACKET INSTALLATION
Position the
bar and the edge of the bracket becomes the reference value,
and then tighten the stabilizer bar bracket mounting bolt.
INSPECTION
Check the bushings for wear and,
Check the stabilizer bar
Check all bolts for condition and straightness:-
STABILIZER LINK BALL JOINT BREAKAWAY TORQUE
CHECK
(1) After shaking the ball joint stud several times, install the
nut to the stud and use the
breakaway torque of the ball joint.
Standard value:
(2) When the measured value exceeds the standard value,
replace the stabilizer link.
(3) When the measured value is low'er than the standard
value, check
excessive play. If so, it is
BALL JOINT DUST COVER CHECK
If there are any cracks in or damage to the dust cover, replace
the stabilizer link.
TSB Revision
B a r
bar so that the making on the stabilizer
,
.
. .
tool to measure the
Nm (4-13
the ball joint turns smoothly without
to use that ball joint.
,