Mitsubishi Eclipse 1990 Service Manual page 884

Select cable
Shift lever
Neutral position
Select cable end
Shift lever
Bushing Bushing A
MANUAL TRANSAXLE
ENGINE (NON-TURBO)>
INSTALLATION SERVICE POINTS
(1) Connect the select cable to the transaxle side select lever.
(2) Set the select lever of the transaxle side at the neutral
position.
(1) Connect the shift cable to the transaxle side shift lever.
(2) Set the shift lever of the transaxle side at the neutral
position.
1
(1) While leaving the shift lever inside the passenger
compartment in the neutral position, install the select cable
to the passenger compartment side of the shift lever.
(2) Install the select cable so that the flange side of resin
bushing is positioned at the edge of lever
(1) While leaving the shift lever inside the passenger
compartment in the neutral position, install the shift cable
to the passenger compartment side of the shift lever.
Install so that the slit section of the bushing
either up or down.
(2) Put the shift lever to all the positions and make sure
that the operation is smooth.
Revision
Transaxle Control
side.
is facing