Mitsubishi Eclipse 1990 Service Manual page 1312

-Transaxle
a sliding hammer, etc., to remove the outer race.
all oil seals.
,
,
REASSEMBLY
(1) Using the special tool, install the oil seals to the differential
bearing retainer and transaxle case.
Differential
bearing
retainer
(2) Use the special tool to press fit the into the'
transaxle case.
(3) Install the transfer shaft.
(4) Place solder with a length of approximately 10 mm
in.) and diameter of 1.6 mm in.) on the output bearing
retainer at the position shown in the diagram and install
the outer race.
TSB Revision