Mitsubishi Eclipse 1990 Service Manual page 1533

FRONT AXLE Drive Shaft
(4) Fill the specified grease to the T.J. case.
Specified grease: Repair kit grease 105
NOTE
The grease in the repair kit should be divided in half
for use, respectively, at the joint and inside the boot.
Caution
The drive shaft joint uses special grease. Do not mix
old and new or different types of grease.
(LARGE) INSTALLATION
Set the T.J. boot bands at the specified distance in order
to adjust the amount of air inside the
tighten the T.J. boot band securely.
Standard value (A): 80
INSPECTION
Check the drive shaft for damage, bending or corrosion.
Check the inner shaft for damage, bending or corrosion.
Check the drive shaft splines for wear or damage.
Check the inner shaft splines for wear or damage.
Check the spider assembly for roller rotation, wear or
corrosion.
Check the groove inside T.J. case for wear or corrosion.
Check the boots for deterioration, damage or cracking.
Check the center bearing for seizure, discoloration or
roughness of rolling surface.
Check the dust cover for damage or deterioration.
TSB Revision
BOOT BAND
3 mm (3.15
(3.70 oz.)
BOOT BAND
boot, and then
in.)
26100280076