Mitsubishi Eclipse 1990 Service Manual page 1344

I
AUTOMATIC TRANSAXLE
OVERHAUL
in.) and diameter of 1.6
retainer at the shown positions
167
to the specified torque.
Output bearing [retainer mounting bolts:
24
and remove the solder. If the solder is
steps
in.)
Measure the thickness of the crushed
micrometer and select a spacer with'
will provide the standard. value for
Standard value:
outer race on the output bearing' retainer.
of the outer bearing retainer.
tighten the output bearing retainer mounting bolts to the ,
specified torque.
Output bearing
24
'168
ring around the bearing.
TSB Revision
-Transaxle
solder with a length
the output bearing retainer and tighten the
Nm (18
the bolts and remove the output bearing retainer.
the outer race from the
using
,
the spacer selected in the previous
a O-ring around: the outer inside diameter
the O-ring with automatic
Nm (18
the output flange into the case and
lb mm
in.) on the output bearing:
the outer race.
bearing 'retainer
repeat
with of 3 mm
'with a
thickness that
. . .
the
and
snap
.