Mitsubishi Eclipse 1990 Service Manual page 1359

AUTOMATIC TRANSAXLE
OVERHAUL
(e) Fit the special tool (outer) to the
Turn the outer cylinder clockwise and the inner cylinder
counterclockwise to unlock the
tool (inner).
Caution
When unlocking is carried
to both special tools to
(f) Tighten the lock nut by hand
Then, use a torque wrench to tighten the lock nut
to the specified torque.
Lock nut: 29 Nm (21
Caution
The lock nut may turn with the adjusting rod
tightened quickly with a socket wrench or torque
wrench.
(g) Remove the special tool for securing the piston. Install
the plug to the Low/Reverse pressure outlet and tight-
en to the specified
ring.
or similar instrument to install it securely.
NOTE
Apply ATF to the oil seal lip and do not scratch it.
the
fluid and install the torque converter.
that dimension A in the diagram is at the standard value.
Standard value: approx. 18.3 mm
TSB Revision
-Transaxle
the switch
the center shaft and hit it with a plastic hammer
pump drive hub with
apply force
the piston.
fasten with a snap
transmission
in firmly so