Mitsubishi Eclipse 1990 Service Manual page 1696

INSPECTION PROCEDURE CLASSIFIED BY DIAGNOSTIC TROUBLE
Code No.
[Comment]
The ABS-ECU detects breaks in the wheel speed sensor wire.
(Refer to
OK
Measure at ABS-ECU connector
Disconnect the connector and mea-
sure at the harness side.
Resistance value between terminals
Wheel speed sensor output voltage check
Check the following connector:
OK
1
Check trouble symptom.
ABS
Wheel speed sensor open circuit
NG
Repair
NG
Check the following connectors:
and
Wheel bearing end play check
Refer to GROUP 26
Service.
Refer to GROUP 27
Service.
NG
Repair
Replace the ABS-ECU.
TSB Revision
Troubleshooting
Probable
Malfunction of wheel
Malfunction of wiring harness or
Malfunction of ABS-ECU
NG
I
O K
On-vehicle
On-vehicle
Repair