Mitsubishi Eclipse 1990 Service Manual page 1464

AUTOMATIC TRANSAXLE OVERHAUL
Underdrive
shaft
Underdrive shaft
No. 3 thrust
assembly
washer
(note 5 tabs)
Overdrive
shaft
(note 3 tabsj
Overdrive
shaft
assembly
No. 3
thrust
washer
2 needle bearing with 3 small tabs facing up.
Dabs of
with dabs of petrolatum.
petrolatum
(for retention)
No. 3 thrust
Now that both shaft assemblies and thrust washers are
properly installed, reinstall overdrive clutch and reverse
clutch as shown in step 19
clearances is not necessary, as they were set and
approved previously.
removing reverse and overdrive clutches, install No.
underdrive shaft assembly.
No. 3 thrust washer.
No. 3 thrust plate onto overdrive shaft assembly
overdrive shaft assembly.
26. Rechecking these clutch