Mitsubishi Eclipse 1990 Service Manual page 1098

AUTOMATIC TRANSAXLE
ENGINE (TURBO) AND
REDUCING PRESSURE ADJUSTMENT
WHEN SCAN TOOL IS NOT USED
1. Remove parts up to the oil filter in the same way as
2. Tune the adjustment screw of the lower valve body and
3. Install the oil filter and oil
4. Perform the oil pressure test. Readjust if necessary.
WHEN SCAN TOOL IS USED
1. Use the scan tool to force-actuate the pressure control
2. Check to be sure, after completing this adjustment, that
TSB Revision
On-vehicle
ENGINE>
for adjustment of the line pressure. The valve body need
not be removed.
adjust so that the reducing pressure is the standard value.
When the adjustment screw is turned clockwise, the reduc-
ing pressure decreases; when it is turned counterclock-
wise, it increases.
NOTE
When adjusting the reducing pressure, aim for the center
value (60 psi)] of the standard value allowance.
Standard value: 415-435
Oil pressure change for each turn of adjustment,
screw: 45 (6.5 psi)
adjustment of the line pressure.
solenoid valve to 50
brake apply pressure at that time. If the
apply pressure is not within the standard value, adjust
using the reducing pressure adjustment screw.
Standard value:
Oil pressure change for each turn of adjustment
screw: 22 (3.2 psi)
the reducing pressure is within the range of
(51-68 psi).
Caution
The adjustment should be made at an oil temperature
of
If the adjustment is made at an oil temperature that
is too high, the line pressure will decrease during
idling, with the result that a correct adjustment cannot
be made.
psi)
in the same way as for
duty, and measure the
(36-44 psi)
23100180033
brake