Mitsubishi Eclipse 1990 Service Manual page 936

I
I
Gear
Synchronizer ring
MANUAL TRANSAXLE'OVERHAUL
INSPECTION
INPUT SHAFT
(1) Check the outer surface of the input shaft where the
needle bearing is mounted for damage, abnormal wear
and seizure [portion A].
(2) Check the
NEEDLE BEARING
Combine the needle bearing with the shaft or
(1)
sleeve and gear and check that it rotates smoothly without'
abnormal noise or play.
(2) Check the needle bearing cage for
201051
SYNCHRONIZER RING
(1) Check the clutch gear teeth for
(2) Check the internal surface for damage,
threads.
(3) Force the synchronizer ring toward the clutch gear and
check clearance "A". Replace if it is out of specification.
Limit: 0.5 mm
2110009
SYNCHRONIZER SLEEVE AND HUB
(1) Combine the synchronizer sleeve and hub and check
that they slide smoothly.
(2) Check that the sleeve is free from damage at its inside
front and rear ends.
(3) Check for wear of the hub end surfaces (in contact with
each speed gear).
Caution
When replacing, replace the synchronizer hub and
201044 sleeve as a set.
TSB Revision
Shaft
.
for damage and wear.
and breakage.
in.)
, ,
. .
and broken