Mitsubishi Eclipse 1990 Service Manual page 1356

AUTOMATIC TRANSAXLE
OVERHAUL
valve body assembly.
a new one.
case hole from the inside.
hole.
keeping the detent plate pin in the 'manual valve groove.
Temporarily install the valve body,
ture sensor and holder; then tighten
to the specified torque.
A bolt: 18 mm
bolt: 25 mm
bolt: 40 mm (1.57 in.)
Valve body assembly mounting bolts: 11 Nm (8
Caution
Firmly fasten the solenoid valve and oil temperature!
sensor harness at the shown positions.
Especially, be sure to route the pressure control
valve
other harness, as shown in the, diagram and clamp
the harness. Failure to fasten
with the detent plate or parking rod.
TSB Revision
-Transaxle
the oil temperature sensor into the case.
an O-ring in the O-ring groove at the' top of the
the solenoid valve harness grommet
the solenoid valve connector through the transaxle
the solenoid valve harness grommet into the case
the knock pin of the
in.)
in.)
harness, which is separated from
body, into case,
the oil'
mounting bolts
'may result in contact