Mitsubishi Eclipse 1990 Service Manual page 1203

AUTOMATIC TRANSAXLE
ENGINE (NON-TURBO)>
(1) Use a transmission jack to support
Caution
Transmission
(2) To make installation easier, use chalk to make mating
marks on the torque converter and drive plate.
(3) Remove the connection
(4)
(5)
the transaxle
I
Front roll
If the dimension shown in the illustration is outside the standard
stopper
value when the weight of the engine is on the body, replace
bracket
the front roll stopper bracket assembly.
ber
Standard value (A)
Temporarily install the drive shaft so that the
drive shaft is perpendicular to the
Caution
Do not damage the oil seal lip by the serrated part of
the drive shaft.
TSB Revision
T O R Q U E
ASSEMBLY MOUNTING
the
the torque converter into the
the transaxle, assembly
ASSEMBLY INSTALLATION
mm
DRIVE SHAFT CONNECTION'
turning the crankshaft.
for easier
and lower
in.)
case of the