Mitsubishi Eclipse 1990 Service Manual page 998

MANUAL TRANSAXLE
Input shaft
input shaft
INPUT SHAFT REASSEMBLY
Input shaft
The snap rings that are used
in select fit sizes. Use the thicknest
in each 'snap ring groove.
(1) Place input shaft into shop press.
gear caged
needle bearing (2) Install
(3) Install
Install
and press on synchronizer hub
nizer hub has the letter
of the hub.
This designates that the hub
"U" facing upward.
(4) Install
(5) Install blocking ring into
caged needle bearing.
(6) Install
gear
TSB Revision
Shaft Reassembly
the input
gear caged needle
gear and synchronizer onto input shaft.
3,
synchronizer snap ring into
synchronizer.
gear onto input shaft.
available
that will fit
on input shaft.
shaft
gear. The
the top
be installed with the
input shaft.
gear