Mitsubishi Eclipse 1990 Service Manual page 961

MANUAL TRANSAXLE OVERHAUL
Specified sealant:
(both sides)
TOOTH CONTACT
1. Standard tooth contact pattern
2. Tooth contact pattern, produced when drive
3. Tooth contact pattern produced when driven bevel
SEALANT APPLICATION TO COVER
A T D P a r t
A . . . . Small end side
. . . . Drive side tooth face
(Side on which force acts
. . . . Big end side
. . . . Coast side tooth face
(Side on which force acts when reversing)
height is too large
Cause
The driven bevel is too close to the drive bevei gear.
Remedy
Use thicker bevel gear mount adjusting spacer to separate
the driven bevel gear more from the drive bevel gear.
gear height is too small
Cause
The driven bevel, gear is too separated from the drive
bevel gear.
or
.
PROCEDURES
running forward)
gear