Mitsubishi Eclipse 1990 Service Manual page 1665

BASIC BRAKE SYSTEM
Prima
piston
Straight scale
- -
Straight scale
Master Cylinder arid Brake
INSTALLATION SERVICE POINTS
m m
Marking
(1) Install the vacuum hose to the brake
shown in the figure. Secure the hose with the hose clip.
Caution
1. The check valve and the pipe part of
2. Connect so that the marking faces upwards.
(2) Install the other end of the vacuum hose fully onto its
port
Adjust the clearance (A) between the brake booster push
rod and
Push rod
Calculate clearance A from
Standard value:
NOTE
When brake booster negative pressure 67
clearance value will become
HOSE CONNECTION
booster must not contact each other.
engine. Secure the hose using the hose clip.
on the
CLEARANCE ADJUSTMENT BETWEEN BRAKE
BOOSTER PUSH ROD AND PRIMARY PISTON
piston as follows:
the
mm
nipple
and measurements.
in.)
(9.7 psi) is applied,
mm in.)