Mitsubishi Eclipse 1990 Service Manual page 1700

Code No. Solenoid valve system
[Comment]
The ABS-ECU normally
If no current flows in the solenoid even if
continues to flow even when turned OFF, the ECU determines the solenoid coil wire
is broken/short-circuited or the harness is broken/ short-circuited, and then these
diagnostic trouble codes are output.
Measure at hydraulic unit connector
Disconnect the connector and
sure at the hydraulic
Resistance value between terminals
7-3, 7-5 and 7-6.
O K
Measure at ABS-ECU connector
Disconnect the connector and mea-
sure at the harness side
Resistance value between terminals
22-17. 22-19 and
Check trouble symptom.
ABS
the solenoid valve drive circuit.
ECU turns the solenoid ON or
Replace the hydraulic unit.
Check the following
NG
OK
NG
TSB Revision
Malfunction of hydraulic unit
it
NG
Replace the ABS-ECU.
Repair