Mitsubishi Eclipse 1990 Service Manual page 1530

FRONT AXLE
Drive Shaft
(5) Use the special tool
Caution
(1) Hold the drive
(2) Crimp the B.J. boot
'touches the stopper.
00003421
(6) Check that the crimped width (B)
value.
Standard value (B): 2.4
00003422
(7) Check that the B.J. boot
the band is secured incorrectly, repeat steps (4) to (6)
to replace it.
(8) Apply the specified amount 'of
Specified grease: Repair
(9) Install the B.J. boot to adjust the clearance (C)
the B.J. boot end and the stepped
housing is within the standard
(lO)Adjust the opening dimension
as mentioned at the step (3).
Standard value (W): 3.2 mm
00003423
TSB Revision
crimp the B.J. boot band
special tool to crimp the B.J.
than 2.8 mm
Readjust the dimension
value calculated by the
and repeat step (5).
5.5 mm
Example: If (B) is 2.9 mm
mm in.).
<When less than 2.4
Remove the B.J. boot
dimension (W) of step
calculated by the following
a new B.J. boot band to
(5).
5.5 mm
Example: If is 2.3
3.2 mm in.).
value (C): 0.1
and use the
special tool
within the stand&d
2.8 in.)
of
in.)
in.), is 2.6
in.)>
in.)
is secured
the
95 'oz.)
,
of B.J.
1.55 mm in.)
to the standard value
the
to
is
If,