Mitsubishi Eclipse 1990 Service Manual page 1073

AUTOMATIC TRANSAXLE
ENGINE (TURBO) AND
brake
pressure
Reducing
pressure
4. Front clutch
pressure
8. Torque converter
'5. clutch
pressure
pressure
6. End clutch
pressure
8. Torque
1. Completely warm up the transaxle.
pressure
2. Raise the vehicle by using a jack so that the
can be rotated.
3. Connect an engine tachometer
Attach the special oil-pressure gauge
4.
sure outlet port.
When the reverse position pressure. is
3,000
Measure each hydraulic
5.
in the standard hydraulic
they are at the standard values.
6.
the
control solenoid
NOTE
1. Vehicle speed: 0 km/h (0 mph)
2. Selector lever switch position: "D"
Low-reverse
3. Accelerator condition: Fully closed.
If the pressure is outside the standard value, repair accord-
7.
ing to the hydraulic pressure
I
brake
TSB
ENGINE> On-vehicle
it's easy to see.
and the adapter
(435 psi) type of gauge should
the tool to
brake
(PCSV)
If all of the above conditions
the actuator for 5 seconds to bring the PCSV to
duty.
23199999949
place it a position
to oil-pres-
be
used.
under the conditions
and check that
actuator, and
(Apply) when the
50
diagnosis chart.
.
.
,