Mitsubishi Eclipse 1990 Service Manual page 1582

l-
- c a s
REAR AXLE
REASSEMBLY SERVICE POINTS
e ( B )
Install the differential cases (A) and (B) with their mating
marks in alignment.
Pinion mate
washer
Attach the differential pinion mate to the pinion shaft with
the pinion washers directed as shown, then assemble them
into the differential case (B).
When the differential side gear and pinion mate gear have
been replaced, select the thrust washer (L.H.) by the following
procedure.
(1) Wash the differential side gear and pinion mate gear
with unleaded gasoline and degrease.
(2) Assemble the thrust washers so far used, without
confusing the R.H. part with the L.H. part and together
with each gear, VCU, pinion mate washer and pinion
shaft, to the differential cases (A) and (B), and loosely
tighten the screws.
(3) Check the differential backlash, and select a thrust washer
(L.H.) to obtain its standard value. (Refer to
TSB
LSD Case Assembly
DIFFERENTIAL CASE
(A) INSTALLATION
DIFFERENTIAL PINION
WASHER INSTALLATION
THRUST WASHER (L.H.) SELECTION
CASE