Mitsubishi Eclipse 1990 Service Manual page 1659

Table of Contents

Advertisement

BASIC BRAKE SYSTEM
When worn
When new
rake disc
Wear indicator
REAR DISC BRAKE' PAD
REPLACEMENT
NOTE
The brake pads have wear indicators that contact the brake
disc when the brake pad thickness becomes 2
The wear indicators emit a
to have the pads replaced
checked.
1. Check brake pad thickness through caliper body check
port.
Standard value: 10 mm
Limit: 2.0 mm
Caution
1. When the limit is exceeded, the brake pads on
as a set.
2. If there is a significant difference
thicknesses of the pads on the left and right
check the
pin sleeve and guide pin sleeve.
2. Remove guide pin. Lift caliper assembly, slide the
assembly toward the inside of the wheel well until
separated from the lock pin. Support it with wires.
Caution
Do not wipe off the special grease that is on the guide
pin or allow it to contaminate the guide pin.
3. Remove the following parts from caliper support.
1. Outer shim
2. Pad assembly
3. Pad and wear indicator assembly
4. Clip
1
TSB Revision
in.)
both the left and right wheels must be replaced
condition of the piston, lock
in.).
to warn the driver
to have the brake system
. .
in.)
,
the;

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents