Mitsubishi Eclipse 1990 Service Manual page 1516

FRONT AXLE
Drive Shaft
INSTALLATION SERVICE POINT
DRIVE
(1) Install the drive shaft washer in the specified
(2) Use the special tool to tighten the drive shaft nut.
Caution
Before securely tightening the drive shaft nuts, make
88
sure there is no load on the wheel bearings.
(3) If the position of the cotter pin holes,
tighten the nut up to 255 Nm
(4) Install the cotter pin in the first matching holes and bend
it securely.
INSPECTION
Check the drive shaft boot for damage or deterioration.
Check the ball joints for wear or, operating condition.
Check the spline part for wear or damage.
TSB Revision
NUT INSTALLATION
'in maximum.
not match,