Mitsubishi Eclipse 1990 Service Manual page 1153

A shift must not be
test must not be in progress; no spike must be detected from the solenoid during the
test, or a pressure switch problem, or a speed problem. The code sets if the solenoid continuity
test failed for the second time, or if there is either a pressure switch or speed data
and the solenoid continuity test failed for the first time.
Measure at the TCM connector
Disconnect the connector and
measure at the harness side.
Resistance value between (19) and
around.
Less than
OK
Measure at the TCM
Measure at the TCM connector
and solenoid and pressure switch
sembly connector
Disconnect the connector and
measure at the harness side.
between
and (7).
OK: Less than
and solenoid and
switch
sembly connector
Disconnect the connector and
measure at the harness side.
Resistance value between
Replace the solenoid and pressure
switch assembly.
AUTOMATIC TRANSAXLE
ENGINE, (NON-TURBO)>
Solenoid circuit error:
an selector lever position, pressure switch, or watchdog
NG
.
Measure at the TCM connector
Check trouble symptom.
Replace the TCM
Measure at the TCM connector
Check the following connector:
Replace the TCM
NG
Check the harness wire between the
TCM and solenoid and pressure stitch
assembly.
(19)
NG
Check the harness wire between the
E A T X
switch
(8)
TSB Revision
, .
Probable
Malfunction of
and TCM
TCM ground open-circuited
Malfunction of TCM
value between (19) and
.
.
NG
NG
and solenoid pressure
or connector between UD
Replace the
switch assembly.
.
the harness wire between
TCM and ground.
Repair
,