Mitsubishi Eclipse 1990 Service Manual page 1753

Caution
Turn the ignition switch off before
If the scan tool is disconnected while the ignition
the
the
1. Jack up the vehicle and
racks
wheels which 'are checked on
force tester.
Caution
The roller of the braking force tester
should
2. When
2.
Release the parking brake, and feel
torque)
using "the
'brake drag
Turn the ignition key to the
scan tool as
lever
1. At this time, the ABS
'2. When the ABS has'
function, the scan tool actuator testing
used.
5. Use the scan tool to force-drive the actuator.
6. Turn the wheel by
force when the brake
using the braking force tester, depress
until
and check to be sure that the braking force changes
to the brake drag force inspected in step 2
actuator is force-driven.
Front wheel
Rear wheel
The result should be as shown in the following
7.
If the result of inspection is abnormal, correct according
to the "Diagnostic Table."
TSB
,
t h e
diagnostic trouble codes will be memorized!
warning' light' may
support: the vehicle with rigid;
at the specified jack-up
the rollers of the braking
be
dry during
the rear brakes, stop
'each road wheel.
force tester, take "a
the
is in neutral, start
mode and the
check the change in
is -depressed.
braking force is at the following values,
.
switch
place the
. .
the
parking!
them. ,
.
can be
the brake
when the
diagram.
__
,
__