Mitsubishi Eclipse 1990 Service Manual page 1786

Pressure gauge
Thermometer
NOTE
' 1 :
(Turbo) and Engine>
Engine (Non-turbo)>
2: Engine (Turbo) and
Engine>
549 Engine (Non-turbo)>
STEERING On-vehicle Service,.
STEERING GEAR RETENTION HYDRAULIC PRESSURE
CHECK
Shut-off valve
Disconnect the
(Fully open)
then connect the' special tools.
I
2. Bleed the air, and then turn the steering wheel several
times while the vehicle is
ture of the fluid rises
3. Start the engine and
4. Fully open the shut-off valve of the pressure gauge.
5. Turn the steering wheel all the way to the
then check whether or not the
is the standard value.
Standard value:
6.
gear box.
Remeasure fluid pressure.:
7. Remove the special tools, and the tighten the pressure
hose to the specified torque.
8. Bleed the system.
TSB Revision
hose
moving so that
approximately
it at 1,000
not within the standard value;
oil pump,
100
right;
pressure
the steering
,