Mitsubishi Eclipse 1990 Service Manual page 868

MANUAL TRANSAXLE
Neutral position
Neutral position
Shift lever
Shift lever
Shift lever
Bushing Bushing A
Slit
Down
(TURBO) AND ENGINE>
INSTALLATION SERVICE
CONNECTION (TRANSAXLE SIDE)
SELECT CABLE
(1) Connect the select cable to the transaxle side select lever.
(2) Set the shift lever of the transaxle side at the neutral
position.
NOTE
When the shift lever of the transaxle side is set at the
neutral position, the select lever of the transaxle side
is also set at the neutral position.
SHIFT CABLE
(1) Connect the shift cable to the transaxle shift lever.
(2) While leaving the select lever at the transaxle side in
the neutral position, move the shift lever at the transaxle
side in the direction of the arrow in the illustration to
set it to
NOTE
If the shift lever does not move easily, depress and hold
the clutch pedal.
CONNECTION (PASSENGER COMPARTMENT
SIDE)
SELECT CABLE
(1) While leaving the shift lever inside the passenger
compartment in the neutral position, install the select cable
to the passenger compartment side of the shift lever.
(2) Install the select cable so that the flange side of resin
bushing is positioned at the edge of lever
SHIFT CABLE
(1) Pull the shift lever at the passenger compartment side
fully in the direction shown in the illustration
position), and install the shift cable to the shift lever at
the passenger compartment side.
Install so that the slit section of the bushing
either up or down.
(2) Put the shift lever to all the positions and make sure
that the operation is smooth.
'TSB
Revision
Transaxle
CABLE AND SELECT
gear.
CABLE AND SELECT CABLE
side.
gear
is facing