YASKAWA Σ-V Series User Manual page 294

9 Appendix
9.1.2 Parameters
Parameter
No.
Input Signal Selection 2
4th
digit
n.
Pn50B
Pn50C
Reserved (Do not change.)
Pn50D
Reserved (Do not change.)
9-16
Name
3rd 2nd
1st
digit digit
digit
N-OT Signal Mapping
0 Valid when CN1-13 input signal is ON (L-level).
1
Valid when CN1-7 input signal is ON (L-level).
2 Valid when CN1-8 input signal is ON (L-level).
3 Valid when CN1-9 input signal is ON (L-level) .
4 Valid when CN1-10 input signal is ON (L-level).
5 Valid when CN1-11 input signal is ON (L-level).
6 Valid when CN1-12 input signal is ON (L-level).
7 Reverse run prohibited.
8
Reverse run allowed.
9 Valid when CN1-13 input signal is OFF (H-level).
A Valid when CN1-7 input signal is OFF (H-level).
B
Valid when CN1-8 input signal is OFF (H-level).
C Valid when CN1-9 input signal is OFF (H-level).
D Valid when CN1-10 input signal is OFF (H-level).
E Valid when CN1-11 input signal is OFF (H-level).
F Valid when CN1-12 input signal is OFF (H-level).
Reserved (Do not change.)
/P-CL Signal Mapping
0 to F Same as N-OT signal mapping
/N-CL Signal Mapping
Same as N-OT signal mapping
0 to F
Setting Factory
Units
Range Setting
0000 to FFFF − 8882
– – 8888
– – 8888
When
Classification
Enabled
After restart Setup
(Refer to 4.2.3)
– –
– –
Reference
Section
−
–
–