Transmission Input Speed Sensor G182 , Removing And Installing; Transmission Output Speed Sensor G195 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

– Disconnect the sensor connector -1- from the transmission
connector.
– Remove the bolt from the 8-pin transmission connector.
– Remove the transmission connector with the wiring harness
outward from the transmission housing.
Install in reverse order of removal. Note the following:
– Coat the O-ring with ATF.
– Push the transmission connector with a new O-ring all the way
into the transmission.
– Tighten the bolt for the 8-pin transmission connector. For the
correct tightening specification. Refer to
– Install the valve body. Refer to
– Install the ATF strainer. Refer to
⇒ 1.2 ATF Strainer, Removing and Installing , page 86
– Install the ATF pan. Refer to
⇒ 1.1 Oil Pan, Removing and Installing , page 84
– Fill the ATF and check the level. Refer to
⇒ 7 Automatic Transmission Fluid , page 73
2.5 Transmission Input Speed Sensor -
G182- , Removing and Installing
– Remove the valve body. Refer to
⇒ 2.2 Valve Body, Removing and Installing , page 90
– Remove the bolt -1- from the Transmission Input Speed Sen‐
sor - G182- .
– Remove the Transmission Input Speed Sensor - G182- from
the transmission housing.
Install in reverse order of removal. Note the following:
– Push the Transmission Input Speed Sensor - G182- all the
way into the transmission housing.
– Install the bolt -1- for the Transmission Input Speed Sensor -
G182- . For the correct tightening specification. Refer to
⇒ page 89 .
– Install the valve body. Refer to
Tightening Specifications
♦ Refer to ⇒ 2.1 Overview - Valve Body , page 87
2.6 Transmission Output Speed Sensor -
G195- , Removing and Installing
– Remove the valve body. Refer to
⇒ 2.2 Valve Body, Removing and Installing , page 90
Automatic Transmission - Edition 11.2014
⇒ page 89 .
⇒ page 95 .
.
.
.
⇒ page 95 .
.
Golf 2015 ➤ , Golf Variant 2015 ➤
.
101
2. Valve Body