1.15
Clutch Position Sensor - G476- , Re‐
moving and Installing
Removing
– Move the driver seat as far back as possible.
– Disconnect the connector -arrow- from the Clutch Position
Sensor - G476- .
– Release the Clutch Position Sensor - G476- -2- tab on the
clutch master cylinder -1- in the direction of -arrow- and re‐
move it.
Installing
Install in reverse order of removal. Note the following:
•
The tab -arrow- on the Clutch Position Sensor - G476- must
remain intact.
•
The Clutch Position Sensor - G476- must engage audibly.
1.16
Clutch Mechanism, Bleeding
Special tools and workshop equipment required
♦ Brake Charger/Bleeder Unit - VAS5234-
♦ Bleeder Hose (670 mm) - VAG1238/B3-
Note
The system must be bled after working on the hydraulic clutch
♦
mechanism.
Make sure no brake fluid gets on the transmission when per‐
♦
forming the following work.
It is not necessary to pre-fill the system.
♦
Before bleeding, fill the brake fluid reservoir to the Max mark‐
♦
ing with brake fluid.
The clutch pedal is in the neutral position and is not pressed.
♦
Brake fluid: Allocation. Refer to the Parts Catalog.
♦
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
37
1. Clutch Mechanism