Table of Contents
Advertisement
container create mvolume
To create a multilevel volume set, use the container create
mvolume command. You can create the following types of
multilevel volume sets:
I
Volume set of stripe sets
I
Volume set of mirror sets
I
Volume set of RAID 5 arrays
I
Volume set of volume sets
Notes
When creating a multilevel array of volume sets on a NetWare
server, you specify the container IDs (as described in the
Parameters section) for the arrays from which you want to create
the multilevel volume set. If NetWare is using any of these arrays,
an appropriate message displays. This message indicates that one
or more of the arrays you specified is in use by NetWare. The
message directs you to remove any NetWare volumes and
partitions from these arrays. You can then create a multilevel array
of volume sets on a NetWare server.
After you create a multilevel volume set you can run the list
devices command on the NetWare console to verify its creation
and then create the necessary NetWare disk partitions and
volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create mvolume [/label{=string}]
{container} [{container}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to create the multilevel volume set.
container Commands
3-17
Advertisement
Table of Contents
