Table of Contents
Advertisement
disk show partition
To display a list of partitions on the disks attached to the currently
opened controller, use the disk show partition command.
Syntax
disk show partition
Examples
The following example shows a sample output from the disk
show partition command:
AAC0>disk show partition
Executing: disk show partition
Scsi
Partition
C:ID:L Offset:Size
------ ------------- --- ------ --- ------ ---
0:02:0 64.0KB:20.0MB 0
The following sections provide more information on the columns
that the disk show partition details command displays.
The SCSI C:ID:L Columns
The C:ID:L column displays the SCSI channel number, the SCSI
device ID, and the SCSI device logical unit number for each disk on
the currently opened controller.
In the example, the command displays the SCSI channel number,
the SCSI device ID, and the SCSI device logical unit number for one
disk (0:02:0) on the currently opened controller.
The Partition Offset:Size Column
The Partition Offset:Size column displays the offset (in bytes) into
the SCSI device and the size of the partition (in bytes). In the
example, the offset is 64.0 KB and the size is 20.0 MB.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk
remove dead_partitions
information on dead partitions.
Array
MultiLevel
Num Type
Num Type
Volume 0
None
(page
R/W
RW
5-10) command for more
disk Commands
5-19
Advertisement
Table of Contents
