Afu Commands - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide
b
Flashing the Firmware on Multiple Controllers
To flash the firmware on multiple controllers, type the
following at the DOS prompt, replacing the comma-
separated list of CONTROLLER_NUMBER_n with the
numbers of the controllers whose firmware you are
updating:
afu update /C
CONTROLLER_NUMBER_1,CONTROLLER_NUMBER_2
To upgrade controllers 0, 2, and 3 for example, you would
type the following:
afu update /C 0, 2, 3
c
Flashing the Firmware on All Controllers
To flash the firmware on all controllers, type the following
at the DOS prompt:
afu update /C all
6
The firmware image may be contained on multiple diskettes.
The AFU prompts you to put in the first firmware diskette.
When it detects that the diskette is in the drive, the AFU will
read the part of the firmware image contained on the first
diskette.
7
The AFU then tells you to remove the first firmware diskette
and insert the second firmware diskette.
8
If there are additional UFI files this process is repeated until
the complete image has been read, then the controller flash will
be updated with the new image.

AFU Commands

The following pages describe each of the AFU commands in detail.
For ease of use, the commands are presented in alphabetical order.
12-8