Adaptec SCSI RAID Software Reference Guide
disk show default
To display the current default for the SCSI device ID, use the disk
show default command. You previously set this default using the
disk set default command.
Syntax
disk show default
Examples
The following example shows the default for a SCSI device ID that
was set in a previous use of the disk set default command:
AAC0>disk show default
Executing: disk show default
Default Scsi: (CHANNEL=0,ID=3,LUN=0)
If no default for a SCSI device was previously specified, the
command displays an appropriate message.
Related Information
disk commands:
■
(page
7-10)
disk set default
7-16