Syntax; Parameters; Examples; Enclosure Show Power - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

enclosure show power

To display the status of a specific power supply on a specific SAF-TE
enclosure management device, use the enclosure show power
command. You can also use this command to display the status of
all power supplies on the enclosure management device or devices.

Syntax

enclosure show power [{enclosure}] [{powersupply}]

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device for which you want to display power supply status
information. For this version, the controller supports a
maximum of eight enclosure management devices on each
bus.
If you do not specify an ID, the command displays the power
supply status for all enclosure management devices connected
to the controller.
{powersupply}
Specifies the unit number associated with the power supply
whose status you want to display. This integer can range from
0 to 15 inclusive.
If you do not specify a unit number, the command displays the
status for all power supplies on the enclosure management
device or devices.

Examples

The following example displays the status of the power supplies on
enclosure management devices 0 and 1:
AAC0>enclosure show power
Executing: enclosure show power
Enclosure Power State
--------- ----- ------------ -------
0 0 OK
1 0 OK
11-30
Status
ON
OFF