Enclosure Set Fan; Syntax; Parameters - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

enclosure set fan

To set the speed of a specific fan on a specific SAF-TE enclosure
management device, use the enclosure set fan command.

Syntax

enclosure set fan [/off{=boolean}] {enclosure}
{fan} [{speed}]

Parameters

{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to set the speed of a specific fan. For
this version, the controller supports a maximum of eight
enclosure management devices on each bus.
{fan}
Specifies the unit number associated with the fan whose speed
you want to set. The unit number for the fan ranges from 0 to
15 inclusive.
{speed}
Specifies the speed at which you want to set this fan.
Table 11-3 lists the fan speed values you can specify.
Table 11-3. Fan Speed Values
Value Meaning
0 Turns off the fan
1 Runs the fan at 1/4 the full speed.
2 Runs the fan at 1/2 the full speed.
3 Runs the fan at 3/4 the full speed.
4 Runs the fan at full speed.
The fan speed defaults to full speed.
11-16