Related Information - Adaptec RAID 2120S Software Reference Manual

3
Assign a drive letter to the volume set created in Step 1 with
the container assign drive_letter command.
4
Create an NTFS file system on the volume set created in Step 1
with the container format command.
5
Create a second volume set of 100 MB on disk (1,1,0) with the
container create volume command.
6
Create a third volume set of 100 MB on disk (1,2,0) with the
container create volume command.
7
Used the container extend mvolume command to add
the arrays created in Steps 5 and 6 to the array created in Step
1.
The following example extends the NTFS file system to make use of
the additional arrays:
AAC0>container extend file_system 0
Executing: container extend file_system 0
The system has been marked to expand the file system on
the next reboot.
Reboot the system to get the file system to expand to
show the new space.
Use the container list command after using the container
extend file_system command to display information about the
array after you extend a file system. Note that there is no change in
the display as a result of using the container extend
file_system command.

Related Information

container commands:
■
container format
(page 5-54)
container Commands
5-45