Task Resume; Syntax; Parameters; Switches - Adaptec RAID 2120S Software Reference Manual

Adaptec SCSI RAID Software Reference Guide

task resume

To resume one or all tasks previously suspended on the currently
opened controller, use the task resume command. You suspend
tasks with the task suspend command.

Syntax

task resume [/all{=boolean}]
[{integer}]

Parameters

{integer}
Specifies the task ID for the task to resume. Perform a task
list /all to display the task IDs for all tasks currently
suspended on the open controller before resuming a specific
task or all tasks.

Switches

/all{=boolean}
Specifies whether to resume all suspended tasks. If you set this
switch to TRUE, the command resumes all tasks that were
suspended on the currently opened controller.
If you do not specify this switch or a valid task ID, the
command displays an appropriate error message.

Examples

Before resuming a suspended task, use the task list command
to identify any suspended tasks, as in the following example.
AAC0>task list
Executing: task list
TaskId Function Done% Array
------ -------- ----- ---------
101 Scrub 24.6% 0
The following example shows the use of the task resume
command to resume task 101, which was previously stopped with
the task suspend command:
AAC0>task resume 101
Executing: task resume 101
10-8
State Specific1 Specific2
----- --------- ---------
SUS 00000000 00000000